time in the 24-Hour Repeating scheduler. This additional time is required
so that the User has time to replace the Scan on Demand vessel with the
24-Hour Repeating vessel.
7.3.2.4 Initiate Scan: Scanning using the Scan on Demand Scheduler is initiated by
clicking the red “Scan” button.
7.4 Finding and Viewing Scanned Vessels
After scans have been generated there are two ways to search and view your vessel of interest;
using View Scans option or the Search option . Once you have located your
vessel using either the View Scans or Search tools, simply double-click on the vessel or use the
“View Vessel” button on the lower right-corner of the window.
7.4.1 Finding Scanned Vessels
7.4.1.1 View Scans Tab: When the ZOOM IncuCyte™ software is launched, it opens
by default to the View Scans screen. The first time the software is opened,
the screen will be empty. However, once scans have been performed, the
software will open to show the very last scan that was completed, as well as
a Time Tree that lists the times and dates for all completed scans.
NOTE: The View Scan screen is recommended for recently scanned vessels.
1. Click through the Time Tree to find completed scans generated on the
device.
2. The center of the View Scan screen will display the Drawer Setup for that
particular scan time. Highlight the vessel of interest to display vessel
properties to the right side of the screen.
3. Once your vessel of interest is located, either double-click on the vessel
or highlight the vessel and click on the “View Vessel” button in the lower
right-hand corner of the screen.
To Next Page
Loading...