Include Error Measurements
Break Data Into Individual Images
Include Experiment Details in the Header
Choose this box to include export of the following additional details along
with the data: the selected Metric (usually confluence), cell type, passage
number, and any notes. If multiple files are exported, the additional details
will appear in every file.
Fill Holes in the Data with the Following Characters
It is possible to set a scan pattern that does not include all the possible wells
or sectors in the vessel. If the data are exported using the Layout option:
“Show each Scan as its Own Table”, the table will have empty spaces where
sectors or wells were omitted from the scan pattern. Rather than leaving
these spaces empty, it is possible to select characters (e.g. “BLANK”) to fill
the spaces.
Include Error Measurements
Use this option to include either standard error (SE) or standard deviation
(SD) for each measurement. Note that SE and SD are not available for
individual images, but are calculated for the selected grouping (all, rows,
columns, none). When “None” is selected, error measurements are available
only if there are multiple images per sector.
Break Data Into Individual Images
When there are multiple images per sector, you have the option to break
data down into measurements from each image.
7.6.3.2 Dragging and Dropping Metrics
It is possible to export the Metrics associated with a particular vessel directly to
another document or to a selected file directly from the Launched Analysis job
within the Vessel View.
NOTE: It is NOT possible to drag and drop a time range. Only data from a single
scan time can be dragged and dropped.
To export data displayed in the Vessel View window follow the steps specified
below;
1. Select the “Graph/Export” tab located within the Vessel View.
2. Select the “View” menu at the top of the screen and uncheck “Condensed
Metrics”.
3. Select the desired assay metric from the drop down menu to be exported.
Located next to the icon.
To Next Page
Loading...