Esu SwitchPilot - Decoder Reset; 14.1. With DCC systems; 14.2. With programming button; 14.3. With ESU LokProgramer

26
Example:
You would like to operate relay outputs 1 and 2 together with
servo outputs 5 – 6 but relay outputs 3 and 4 should be switched
in parallel to transistor outputs 3 – 4. Therefore, write the value
3 into CV 49. As soon as you want to switch the relay outputs
together with the servo outputs the time of switching will be
delayed automatically.
14. Decoder reset
You can reset to the factory defaults at any time:
14.1. With DCC systems
Write value 08 into CV 08.
Please keep in mind that the reading of CV 08 will show the
value 151 (manufacturer ID of ESU). Writing the value 8 to CV 8
is a special case. Therefore, a few central units show „err02“ or
similar errors. However, the SwitchPilot still accepts the command.
14.2. With programming button
• Disconnect the power to the SwitchPilot decoder
• Press and hold the programming button at the SwitchPilot
• Reconnect the power to the SwitchPilot. The decoder will be
reset to factory defaults.
• Release the programming button.
14.3. With ESU LokProgramer
In the menu „Edit CVs“, option „Read/Write CVs“ write the value
08 into CV 08.
Decoder reset
15. Support and assistance
Your model train dealer or hobby shop is your competent partner
for all questions regarding your SwitchPilot decoder. In fact he is
your competent partner for all questions around model trains.
Of course, you may also contact us directly. For enquiries please
use either email or fax (don’t forget to provide your own fax-no.
or email address) and we will reply within a few days.
Please call our hotline only in case of complex enquiries that
can’t be dealt with by email or fax. The hotline is often very
busy and you may encounter delays. Rather send an email or
fax and also check our website for more information. You will
find many hints under “Support / FAQ” and even feedback from
other users that may help you with your particular question.
Of course we will always assist you; please contact us at:
Contact Germany:Contact Germany:
Contact Germany:Contact Germany:
Contact Germany:
Phone: ++49 (0) 700 – 56576863 (Tue&Wed 10am -12am)
Fax : ++49 (0) 700 - 37872538
Email: support@loksound.de
Warranty address: ESU GmbH & Co. KG
- technischer Support -
Industriestrasse 5
D-89081 Ulm
Contact USA:Contact USA:
Contact USA:Contact USA:
Contact USA:
Phone: +++1-320-202-0865
Fax : +++1-320-202-0867
Email: support@loksound.com
Warranty address: ESU LLC
815 60th Ave SE
56304 St Cloud
www.esu.eu