ES4440.2 Compact Failure Simulation Module - User’s Guide10
Introduction ETAS
1.3 Identifications on the Product
The following symbols are used for identifying the product:
Observe the information in chapter "Technical Data" on page 49.
1.3.1 CE Marking
ETAS confirms that the product meets the product-specific applicable European
Directives with the CE marking affixed to the product or its packaging. The CE
Declaration of Conformity for the product is available upon request.
1.3.2 KC Mark
With the KC mark attached to the product and its packaging, ETAS confirms that
the product has been registered in accordance with the product-specific KCC
guidelines of the Republic of Korea.
1.3.3 RoHS Conformity
European Union
The EU Directive 2011/65/EU limits the use of certain dangerous materials for
electrical and electronic devices (RoHS conformity).
ETAS confirms that the product corresponds to this directive which is applicable
in the European Union.
Symbol Description
Before using the product, carefully read the user’s guide!
Identification for CE (see "CE Marking" on page 10)
Marking for KCC conformity
(see "KC Mark" on page 10)
Identification for China RoHS (see "RoHS Conformity"
on page 10)
Identification for WEEE directive
(see "Taking the Product Back and Recycling" on page 12)
To Next Page