The relay will be toggled to the "Normally Open" position as shown below.
The relays can also be toggled with RMS-200 relay Scripts. Relay scripts are made up of
simple commands that control the relays. Complex relay actions can be performed to control
your equipment. For example; starting a generator.
Below is a screen shot of making a relay script to toggle relay 1 on, wait 2 seconds, then
toggle relay 1 off again.
Each relay can have a name and its actions defined. Below is a screenshot of a relay
script that turns a pump on for 30 minutes and then turns it off again.
To Next Page
Loading...