Need More Voltmeters?
If the six on board voltmeters on the RMS-200 board are not enough for your needs, you
can add six additional isolated voltmeters by adding a USB isolated voltmeter board.
The USB Isolated Voltmeter Board gives you control of six +/- 100vdc isolated voltmeters
via the standard USB Bus. See the USB Isolated Voltmeter user manual for additional
information on how to hook up the USB Isolated Voltmeter Board to your RMS-100, RMS-
200 or RMS-300 unit. To access the USB Isolated Voltmeter Board interface, go to the
Device Manager and click on the USB Isolated Voltmeter Board Icon shown below.
If a USB Isolated Voltmeter Board gets detected by the RMS-200 system, it will show up
in the product ID box shown below. Decide if the USB Isolated Voltmeter board should be
active when the RMS-200 board boots, then press the OK button to add an icon to the
main left navigation bar
To Next Page
Loading...