GPIO
Below is a pinout diagram of Con 8 on the RMS-200 board. These are 3.3 volt general
purpose I/O pins.
Note:
Pin 1 is VDD (3.3
volts).
Pin 2 is General
Purpose I/O pin 1.
Pin 3 is General
Purpose I/O pin 2.
Pin 4 is General
Purpose I/O pin 3.
Pin 5 is General
Purpose I/O pin 4.
Pin 6 is GND.
ALARMS
Below is a pinout diagram of the Alarm pins on the RMS-200 board. These input pins are
pulled up to 3.3 volts.
Note:
JP1 - Pin 1 is Alarm input 1. Pin
2 is GND.
JP2 - Pin 1 is Alarm input 2. Pin
2 is GND.
JP3 - Pin 1 is Alarm input 3. Pin
2 is GND.
JP4 - Pin 1 is Alarm input 4. Pin
2 is GND.
JP5 - Pin 1 is Alarm input 5. Pin
2 is GND.
To Next Page
Loading...