Decide which type of upgrade that goes with the firmware you downloaded and click on the
appropriate browse button to locate the firmware image. When the firmware image is
selected, click on the Upgrade button. After a time you should see similar output as below.
The file rootfs-675-1182185503 has been uploaded
Starting Root File System Upgrade...
Stopping processes ...
Sending TERM signal ...
Most processes stopped.
Erasing 128 Kibyte @ 0 -- 0 % complete. Cleanmarker written at 0.
Erasing 128 Kibyte @ 20000 -- 0 % complete. Cleanmarker written at 20000.
Writing data to block 0
Writing data to block 20000
Checksum = 2020866943
File Stamp = 2020866943
Root File System upgrade complete....
The unit will now reboot.
To continue, please connect to the unit again.
There may be a short delay before the new connection is accepted.
This connection will now close.
When the firmware programming is complete, the RMS-200 board will reboot with the new
firmware image. Wait 45 seconds and then reconnect. When connection is reestablished you
may configure the RMS-200 board, upload your data base, add scripts etc.
To Next Page
Loading...