EasyManua.ls Logo

EtherTek Circuits RMS-200 - Page 7

Default Icon
51 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
R E M O T E M O N I T O R I N G M A D E E A S Y !
Features
Six layer PCB with Nickel Immersion Gold plating and red solder mask.
400 - MHz Arm Processor (500 Mips !).
256 - megs of Nand Flash. Create and store custom applications.
64 - megs of SD-Ram.
Dual Low Noise Switching Power Supplies accepts 8 - 60 vdc input. Can be powered
directly from 12, 24, or 48 volt battery banks.
Battery backed-up, real time clock.
One onboard temperature sensor –25c +100c.
Six 24 bit isolated voltmeters (+/- 100 VDC). Each voltmeter has its own 24 bit Delta
Sigma ADC.
Each voltmeter can be put into low voltage shunt mode (+/- 2 VDC).
Two Power Relays for devices using 1 – 240v -5 amps AC/DC current.
One Power Relay for devices using 1 – 240v -15 amps AC/DC current.
Two programmable push buttons.
Four general purpose I/O pins.
Five dedicated alarm pins.
Power output port, 5.0vdc (500ma).
One full serial port for controlling cell phones, modems, etc.
One console serial port.
Two USB 2.0 ports for cameras, wireless clients, extra Ethernet, etc.
Runs real Linux! 2.6.33 kernel.
Send SMS messages, Email alerts, SNMP traps, Remote Syslog Messages.
Ping watchdog, power cycle equipment after a set amount of ping timeouts.
Command line utilities: ping, ftp, email, relays, etc.
Flash new firmware over the internet.
Duel Watchdog Reset circuits, processor integrated, and extra hardware.
2