ETS e1 - The Tanning Session Procedure

e1 Assembly and User Manual - 23
30596-02A
The Tanning Session
(Operation as a stand-alone unit or con-
nected to a remote system using a control
relay. If using T-Max® see right.)
Lift the canopy, lie down on the bench 1.
(face up), lower the canopy toward your
body using the canopy handle. See Safe-
ty Information for positioning instruc-
tions.
Put on your safety goggles.2.
Press the timer button (G) to begin the 3.
tanning session. The lamps will turn on
and the timer will begin to count down.
If a tanning time less than the displayed 4.
time is desired repeatedly press the tim-
er button (G) to decrease the remaining
time.
When the timer reaches 0 the lamps turn 5.
off. If you want to stop your session be-
fore time expires, press the stop button
(F). You will have ten seconds to restart
with the remaining time, otherwise the
timer will reset to 0.
Raise the canopy by using the outer 6.
edge of the canopy, do not push up on
the acrylic shield. The cooling fans run
for a period of time after the lamps shut
off to aid in cooling the sunbed.
(Operation while connected to a T-Max®
remote system. If using other remotes or no
remote system, see left.)
Lift the canopy, lie down on the bench 1.
(face up), lower the canopy toward your
body using the canopy handle. See Safe-
ty Information for positioning instruc-
tions.
Put on your safety goggles.2.
Assuming the remote system has been 3.
set to allow a pre-tanning delay time, the
timer display (E) will repeatedly fl ash the
delay symbol “dL” and then the remain-
ing delay time. Press the timer button (G)
or wait until the delay time has expired
to begin the tanning session. The lamps
will turn on and the timer will begin to
count down.
When the timer reaches 0 the lamps turn 4.
off. If you want to stop your session be-
fore time expires, press the stop button
(F).
Raise the canopy by using the outer edge, 5.
do not push up on the acrylic shield. The
cooling fans run for a period of time after
the lamps shut off to aid in cooling the
sunbed. The timer will indicate “..” as a
reminder to clean the sunbed. After the
sunbed is cleaned press the timer button
and the display will return to “0”.