6 - e1 Assembly and User Manual
30596-02A
Unpacking and Inspection
Your sunbed comes in two cardboard car-
tons, one for the bench and one for the
canopy. Open the cartons and remove the
bench and canopy as follows.
The bench is packed upside-down in its box
for ease of removal. Simply stand the box up
on the long side so the back of the bench
rests on the fl oor (see right). Then carefully
tip the bench out of the box.
The canopy is packed wrapped in plastic.
Pull back the plastic and, with a helper, grasp
the canopy and pull it from the carton bot-
tom, leaving the plastic wrap and the carton
packaging. Do not attempt to lift either unit
with the plastic still on as it may slip.
Note! The cartons are reusable. You may
wish to save them for future use.
As you unpack your boxes you should fi nd
the following:
Canopy unit•
Bench unit•
Pair of gas springs•
Bag containing necessary assembly •
hardware, safety goggles and pillow
Gas spring cover panel•
Inspect these items, including the canopy
and bench, and make sure they are free from
any visible damage. Report the extent of any
damage to the transportation company.
Record the serial numbers of the canopy
and bench in the area provided at the back
of this manual. This information will be re-
quired whenever you call customer service.
Tools Required
You will need the following tools to assemble
your sunbed.
Utility Knife
#2 Phillips
Screwdriver
7/16” Wrench
Unpacking the bench
To Next Page
Loading...
