e1 Assembly and User Manual - 3
30596-02A
Thank you for purchasing this tanning bed.
It has been designed to provide years of de-
pendable service for you.
Please read all the instructions in this booklet
before installing and using the unit. Always
be sure to observe all safety precautions.
Shock hazard.
Disconnect power before
servicing.
WARNING
Air from the room is used to cool the
sunbed. Maximum ambient room tem-
perature should be 80°F. Place your
sunbed no closer than 6” from any
wall. Make sure nothing obstructs the
airfl ow into or out of the fan openings.
A poorly ventilated room may cause
the unit to become hot and cause dis-
comfort to the user.
CAUTION
Proper assembly of your sunbed
requires three people. Plan to have a
couple of helpers assist you.
CAUTION
Contents
Warranty ..................................................2
Safety Information ................................ 4-5
Unpacking and Inspection ........................6
Tools Required..........................................6
Pre-installation Planning ...........................7
Hardware Inventory ..................................8
Assembly Procedures ................................9
Electrical Connections ............................16
Remote Connections ..............................17
Operation ...............................................21
Care and Maintenance ...........................24
Lamp and Acrylic Replacement ..............25
Troubleshooting ......................................27
Use of a voltage source above 245V AC
may prevent proper operation of the sun-
bed and could cause damage and void the
warranty.
CAUTION
To Next Page
Loading...
