e1 Assembly and User Manual - 7
30596-02A
Pre-installation Planning
Before you begin to assemble your sunbed,
you should observe the following consider-
ations.
Electrical Requirements
You are responsible for preparing the facility
for your tanning bed. Please have an electri-
cian present at the time your tanning bed is
installed. That way the installation crew can
fully verify all functions before they leave.
This unit runs on 220VAC service and must
be hardwired directly to a junction box on a
dedicated circuit. A professional electrician
is recommended for electrical installation.
See the back cover of this manual for power
requirements.
See page 16 for wiring instructions.
Use of a voltage source above 245V
AC may prevent proper operation of
the sunbed and could cause damage
and void the warranty.
CAUTION
Proper assembly of your sunbed
requires 3 people. Plan to have some
helpers assist you.
CAUTION
Air from the room is used to cool
the sunbed. Maximum ambient room
temperature should be 80°F. Place
your sunbed no closer than 6” from
any wall. Make sure nothing obstructs
the airfl ow into or out of the fan open-
ings and endcaps. A poorly ventilated
room may cause the unit to become
hot and cause discomfort to the user.
CAUTION
To Next Page
Loading...
