e1 Assembly and User Manual - 27
30596-02A
ISSUE RESOLUTION
Sunbed not tanning
Lamps fail to light and timer
display is blank
One or more lamps fail to
light
The face tanners will not
come on
The canopy will not stay up
The last minute of tanning
time does not count down
from 59 seconds, but some
time less than 59 seconds
I forgot what address, or
“id”, I set my sunbed to
1. Clean sunbed, see Thorough Periodic Cleaning.
2. Ensure supply voltage is between 200 and 245V AC.
3. Replace lamps if lamp hours are greater than 700hrs.
4. Replace acrylic.
1. Make sure the unit is connected to a power source.
2. Check source of AC power. Reset circuit breaker or re-
place fuse.
1. Check that lamp is installed correctly.
2. Switch unlit lamp with a lamp that lights, if new lamp lights
and old lamp still does not, replace old lamp.
1. Face tanners will not relight for 1 minute if turned off.
2. Replace face tanner lamp, see Removing/Replacing Face
Tanner Lamp.
NOTE: Gas springs are manufactured to hold the canopy in its
fully open position as well as allow it to rest fully closed. If
left open for an extended period of time some creep down
may occur. This is considered normal. Keep the unit closed
when not in use. If the canopy will not stay fully open
when raised...
1. Raise and lower the canopy a few times to lubricate gas
spring internal seals.
2. Replace gas springs.
If the timer button has been pressed to decrease tanning
time during the session, the time expired in the current
minute is subtracted from the last minute.
By holding the body fan button for 3 seconds the timer dis-
play will briefl y display three numbers; the installed timer
software version, a factory set timer code and then the sun-
bed’s “id” number.
To Next Page
Loading...
