28 - e1 Assembly and User Manual
30596-02A
ISSUE RESOLUTION
Timer display is indicating
Er 91
Timer display is indicating
Er 92
Timer display is indicating
Er 93
Timer display is indicating
Er 94
Timer display changes to in-
dicate a tanning time after
the timer button is pressed
but lamps do not come on
My bed is connected to
the T-Max® Manager re-
mote system and when the
delay time has expired the
timer display starts counting
down but the bed lights do
not come on
My bed won’t work with the
T-Max® Manager remote
system
Timer display continues to
show a 0 after the timer but-
ton is pressed
Timer software error. Disconnect and reapply power to the
unit.
Current sensor indicating unit is off when it should be on.
Contact servicer.
Current sensor indicating unit is on when it should be off.
Contact servicer.
Requested session time exceeds maximum time allowed.
1. Bypass plug is not installed, see Electrical Connections.
2. A non-SunStar® bypass has been used. See Electrical Con-
nections.
3. If remote is being used, other than T-Max® Manager, the
external timer may not be activated.
4. Remote wiring is incorrect, see the instructions provided
with the remote interface kit.
The auto start feature of the remote system is disabled, see
the instructions provided with your remote system.
1. The sunbed must fi rst be set to a unique address, see Re-
mote Connections.
2. The bypass or terminator plug may be installed in the series
in an inappropriate location. Plug the bypass plug only
into the bed at the end of the series.
1. T-Max® Manager remote system has not yet been set.
2. Sunbed address is not set correctly, see Remote Connec-
tions.
To Next Page
Loading...
