26 - e1 Assembly and User Manual
30596-02A
Unfi ltered light from face tanner
can cause severe burns.
Never turn sunbed on while face
tanner is disassembled or when
glass fi lters are removed.
Immediately discontinue use of
this equipment if face tanner glass
is broken or any unfi ltered light
can be seen escaping face tanner
assembly.
DANGER
Removing/Replacing Face Tanner
Lamps (if equipped)
After removing the canopy acrylic shield, re-
place the face tanner lamp as follows:
Support the face tanner assembly with 1.
your hand while unscrewing the two
retaining screws. The face tanner glass
casing will swing downward.
The lamp can now be exchanged. The 2.
lamp holders are equipped with spring
contacts which enable the lamp to be re-
moved easily. Remove the old lamp and
discard. Install the new lamp, using a
clean cloth or paper towel. Ensure that the
lamp is fi rmly seated in the lamp holders.
Note! Never take hold of the lamp such
that your fi ngers are in contact with the
lamp glass. Finger oils will greatly re-
duce the lamp’s operational life.
Gently close the face tanner glass cas-3.
ing and lock it closed with the screws.
Ensure that the screws fi rmly secure the
glass casing.
RETAINING
SCREWS
To Next Page
Loading...
