AUDIO | VIDEO MEDIA CONTROLLER
USER GUIDEMC Transport Operation
28
The Jog Wheel can be programmed to generate a Custom Command to send key-
strokes into the application. See page 48 to learn how to do this.
All Wheel functions (positioning, zooming, trimming, Assignable Knob, Control
Room Volume, Custom) are initiated by pressing an assignable key.
For more information on how to set up these programmable functions in EuControl
and which applications allow them, see Chapter 6: Soft Keys.
4.6.2 Shuttle Ring
The Shuttle Ring’s main purpose is to shuttle through a project’s timeline. The
farther it is turned, the faster it shuttles. The Shuttle Ring can also have different
functions assigned. See see Chapter 6: Soft Keys for more information.
4.7 Application/Workstation Key
Press the Application/Workstation key to toggle between the two most recently
used open applications. Hold down the Application/Workstation key and turn
the Jog wheel in either direction to switch between all open applications in a circle.
Figure 4-7 Application/Workstation key
The MC Transport can control applications running on a second computer, referred
to in this guide as a workstation. Press and hold the Shift key and press the
Application/Workstation key to attach the MC Transport to another workstation.
You must first use EuControl to create a list of workstations that this key switches
between (see Workstations on page 35).
While attached to a second workstation, your Mac’s keyboard and mouse can be
configured to control that workstation and not your Mac (see page 36).
Application/
Workstation
key
To Next Page
Loading...
Need help?
General