AUDIO | VIDEO MEDIA CONTROLLER
USER GUIDEEuControl
35
5.2 Workstations
An Artist media controller can control applications running on a second computer,
referred to in this guide as a workstation. The Workstations tab establishes the
list of workstations that the WORKSTATION key cycles through. Any workstation
running EuCon software can be in this list, including those controlled by the
System 5-MC, MC Pro, and MC Control.
Figure 5-3 Workstations tab
All Workstations
All Workstations lists all EuCon-enabled workstations on the network. If the
workstation is already in the My Workstations list, it is shown in gray and cannot
be selected.
My Workstations
My Workstations lists the workstations that can be attached to by pressing the
WORKSTATION key.
It is possible to put a workstation in the My Workstations list that is already
attached to another instance of EuControl running on another computer. It
cannot be attached here until it is unattached from the other instance of EuControl.
This was done to allow multiple users to share workstations without having to
frequently edit their My Workstation list.
To Next Page
Loading...
Need help?
General