Unable to Set
13
Unable to Set
If attempts to Part, Half, Area or Full Set the system fail, the system buzzer briefly sounds and the display
briefly shows:
This is normally due to an zone or door being open away from the exit route.
✍ The system will display which zones are open. In an multi-area system, the display does
not indicate which zones are open until you press the key.
For example:
Action to take:
l Go to the Area concerned and close the zone(s).
l Return to the keypad and reselect the required ‘set’ mode.
l Leave via the exit route.
The system buzzer will stop when:
1. The Exit time expires or
2. When the ‘exit terminator’ button is pressed (if fitted).
To Next Page
Loading...
