Edit Time Commands
35
Edit Time Commands
An automatic time command is a programmed command string which
instructs the 3GS to execute a function at a pre-set time. For example,
the system could be instructed to automatically Full set the premises at
18:00.
Certain time commands are for installer use only, as indicated below.
The other commands are for Master User use.
This mode is a simplified "time command edit" function which allows the
Master User to modify the TIME at which the action will occur without
allowing alteration of the command.
The new time must be valid (24-hour format) or the procedure will not
continue.
After adjustment is made the key should be pressed to program
the new time into the system.
Movement forward and backward through the time strings is provided
by the UNSET and PART keys.
SUNDAY HOUR
Checks for Hour change on Sundays. Installer user only.
LOG DUMP
Sets dial-out variable for system to dial a remote PC/Printer. Installer user
only.
AREA 1 10M WARN to AREA 8 10M WARN
Automatic arming commands for Areas 1 to 8.
These commands (one for each block) start a 10-minute warning time (to
inform people that they must leave the building) after which time the
relevant area will arm.
BATTERY TEST
This command sets a time (1 per day) at which an automatic battery test
will be carried out. Installer user only.
FULL SET 10M WARN
Automatic arming command for the full system. Works in the same way
as the Area 10-minute Warning but in this case the full system will arm.
Late working time commands
These commands allow for late working on the premises. They will arm
the system/area if the first arming time command is cancelled. These are:
L.W. AREA1 WARN to L.W. AREA8 WARN
L.W. FULL SET WARN
E.g. AREA1 10M WARN may be set to 7pm and the L.W. AREA1 WARN
set to 9pm. Normally the first time command would arm the area 1 at
7pm. However, if the user cancels the first time command in order so
that he/she may work late then the first time command is ignored and
the system will be armed by the second time command at 9pm.
SIA TEST CALL
Sets a communication parameter. Installer use only.
To Next Page
Loading...
