Manual Door Control
33
The Manual Door Control
feature gives the user a manual
over-ride on all system door
settings.
At any stage, the user can use this
menu to open/lock a door or
series of doors.
Once you have selected your
doors, the system will check for
Lock/Open Inhibits operating on
these doors (see Open/Lock
Inhibit in the System Integration
manual). If none have been set,
the doors can be opened/locked
via the keypad.
The
Open menu allows you to
open a range of doors
permanently - i.e. the door will
remain open until you manually
restore the original door settings,
or momentarily - you can open
one door for the number of
seconds for which the door lock
would normally remain open
once access has been granted
(see Door Open Time in System
Integration manual).
When you select
Permanent, you are prompted to enter the range of door numbers you wish to open. Enter
the From and To ranges. When the Permanent condition is set on a door, the green LED (access granted) on
the node will flash. This allows free access through the doors selected until restored or locked.
The
Momentary sub-menu will ask you for the number of the door you wish to open momentarily. Again,
enter the number. The green LED will light steadily while access is granted.
Restore restores all door settings to their defaults. Enter the range of doors to be restored and press
to accept and quit. Once defaults have been restored, the system is in normal operation and no LEDs are lit.
The
Lock menu works similarly to Open. When the Lock is manually set on a door, the card reader attached
to the door will not read or accept any cards. When the door is locked in this way, the red LED flashes to
indicate access denied.
Select the range
of doors to be
permanently
opened / restored
OPEN RESTORE LOCK
Unset Part Help
MANUAL DOOR CONTROL
PERMANENT MOMENTARY
Unset Help
FROM DOOR NO. 1
Door 1
ENTER DOOR NO. 1
Door 1
TO DOOR NO. 64
Door 64
#
#
#
HALF
HELP
HELP
UNSET
To Next Page
Loading...
