EVCO S.p.A.
c-pro 3 nano CHIL | Application manual ver. 1.0 | Code 144CP3NCHE104
page 80 of 90
To fit the RS-485 MODBUS network termination resistor, place micro-switch 1 in position ON. To fit the CAN network termination
resistor, place micro-switch 2 in position ON.
PRECAUTIONS FOR ELECTRICAL CONNECTION
- if using an electrical or pneumatic screwdriver, adjust the tightening torque
- if the device has been moved from a cold to a warm place, the humidity may have caused condensation to form inside. Wait about
an hour before switching on the power
- make sure that the supply voltage, electrical frequency and power are within the set limits. See the section TECHNICAL
SPECIFICATIONS
- disconnect the power supply before doing any type of maintenance
- do not use the device as safety device
- for repairs and for further information, contact the EVCO sales network.
To Next Page
Loading...
