EVCO S.p.A. EVFTFT618 | Installer manual ver. 2.2 | Code 144FTFT618E224
Page 11 of 62
3.3 User interface installation
Back panel via studs
3.4 Control module installation
On flat surface, with spacers.
3.5 Installation warnings
- make sure that the device work conditions (temperature of use, humidity, etc.) lie within the limits
indicated; see chapter 0 15 TECHNICAL DATA
- do not install the device near to any heat sources (heating elements, hot air ducts etc.), equipment
containing powerful magnets (large diffusers, etc.), areas affected by direct sunlight, rain, humidity, excessive dust,
mechanical vibrations or shocks.
- any metal parts in proximity of the control module must be at a distance such that they do not
compromise the safety distances; any wiring must be positioned at least 2 cm
- in compliance with Safety Standards, the device must be installed correctly and in a way to protect
against any contact with electric parts; all parts that ensure protection must be fixed in a way that they cannot be
removed without the use of tools.
To Next Page
Loading...
