NexLog Recorder User Manual v2.2.0 133
Appendix E: Alert Codes
In the course of operation, the recorder may generate a variety of alerts, which
are messages about aspects of the system operation. These messages have
different severity levels that range from informational messages to severe errors.
You can configure how alert notification is handled, as well as other alert
features.
This section describes how to configure alert notification, including where to
display and email the alerts. It also provides the following information about
alert messages:
Table 12—Alert Severity Levels: A list of alert severity levels and descriptions.
Table 13—Alert Messages below: A list of alert messages, including the alert
code, severity level, & message text.
Table 12—Alert Severity Levels
An informational message or notice that does not require
acknowledgement. Example: Alert #8, “Recorder Startup.”
Indicates trouble. Example: Alert #6004, “Primary RAID mount failed and
the recorder recovered when secondary mount succeeded.
Indicates an error that could result in possible loss of data. Example:
Alert #5010, “The UPS on recorder <name> was found but is not
functioning properly.”
Indicates a serious problem. Example: Alert #9024, “Analog input Board
<name> has malfunctioned and has been disabled.”
Table 13—Alert Messages
The system has received a test alert
The system has received a test alert(Auto
Resolution)
The system has received a test alert(Manual
Resolution)
To Next Page
Loading...
