NexLog Recorder User Manual v2.2.0 17
– Access active alarms on the recorder
Replay screen
– Research and playback recordings stored locally and on archives
– Export recordings to removable media.
Setup screen
– Configure the recorder.
Login screen
– This option is only visible and available under certain configurations. This
will be explained later during System Security Settings.
When you have finished viewing each screen, you can shut down the unit as
follows:
Important! Do not force a shutdown by pulling the power plug or using the
power switch. A forced shutdown can result in corrupted files
and loss of data.
1. Go to the SETUP screen.
2. Select System.
3. Select Power Off.
4. Select the Shutdown button.
5. Answer OK to the prompt.
After the recorder completes its controlled shutdown procedures, the unit will
automatically shut down.
2.4. Installation
CAUTION NexLog Recorders can be quite heavy, depending upon the model and options.
Do not attempt to lift or install these units without assistance. Do not attempt to
rack mount any model without either shelf or rack-slide support. Rack slides
are available as an option from Eventide. Do not support these units using only
the mounting ears.
2.4.1. General
NexLog Recorders are computer equipment. They have essentially the same
requirements, both physical and electrical, as standard servers, and similar
attention should be paid to their environment to assure long life and reliable
operation. Site preparation, especially for larger installations, may include
To Next Page
