Customer Service 1-888-707-1880
Or email customerservice@dyaco.ca 20 Dyaco Canada Inc.©2021
USER DIRECTION
HOW TO MOVE THE ROWER
To move the machine, lift up the rear stabilizer until the transportation wheels on the front stand
touch the ground.
With the wheels on the ground, you can transport the rower to the desired location with ease.
HOW TO ADJUST THE PEDAL STRAP
To adjust the pedal strap, remove the Velcro end of the strap
from the mesh side by pulling it upward, then to the left.
Once removed, you may increase the opening of the pedal
strap by pulling the mesh end up and to the right.
To tighten, pull the Velcro end of the pedal strap upward
then to the right and down to secure it to the mesh side of the strap.
MAINTENANCE
The safety and integrity designed into the rower can only be maintained when the rower is
regularly examined for damage and wear. Special attention should be given to the following:
1. Adjust the TENSION KNOB (30) and verify that the Magnetic Brake System provides tension.
The Magnetic Brake System should provide many years of use.
2. Clean the roller tracks in the RAIL with an absorbent cloth.
3. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and
bolts. Tighten loose nuts and bolts.
4. Verify that the CAUTION LABEL is in place and easy to read.
5. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
6. Worn or damaged components shall be replaced immediately, or the rower
removed from service until repair is made.
7. Only Dyaco Canada supplied components shall be used to maintain/repair the rower.
8. Keep your Everlast rower clean by wiping it off with an absorbent cloth after use.
To Next Page
Loading...
