Customer Service 1-888-707-1880
Or email customerservice@dyaco.ca 22 Dyaco Canada Inc.©2021
GENERAL MAINTENANCE
The safety of this product can be maintained only if regular periodic checks are made. Most
checks can be performed once a week. However, some checks should be made before each
workout and are indicated as such below.
Checks
• Check that pedals hardware is secure; hardware can work loose over time.
• Check that stabilizer bolts are tight; check before each workout.
• Check that sliding rail is secure; if not, tighten, check before each workout.
• Should a part become defective, replace it immediately. Do not allow use of the equipment
until it has been repaired.
Cleaning
A damp cloth is sufficient to clean most surfaces of this unit. Be careful not to drip water on the
monitor. A mild liquid soap may be added if needed.
HOW TO ADJUST THE DRIVE BELT
If you can feel the flywheel slip while you are pulling, even when the resistance is adjusted to
the highest level, the drive belt may need to be adjusted.
To adjust the drive belt,
the pedal (12) & the chain cover (9&10) must first be removed.
The first step to remove the two sets of Outer Hexagonal Screw (50) and Pedal Bushing (64).
The second step to remove the Crosshead Screw (75&76) from each side of chain cover.
The third step is to loose or tighten the nut (58) to adjust the belt tension.
The last step is attach the chain covers (9&10) & pedal (12) to mainframe.
76
76
76
75
75
75
12
12
64
64
50
50
9
58
58
To Next Page
Loading...
