2
TABLE OF CONTENTS
SPECIAL NOTICE AND CALIFORNIA PROPOSITION 65 WARNING 3
CUSTOMER GREETING AND EXPLANATION OF PROCEDURES 4
WARRANTY AND CONTACT INFORMATION 5
SAFETY DISCLAIMER AND HF WARNING 6
SAFETY WARNINGS, DANGERS, CAUTIONS AND INSTRUCTIONS 7
GENERATOR OPERATION, OPERATING VOLTAGE AND OTHER GENERAL INFORMATION 10
DUTY CYCLE EXPLANATION STATEMENT 11
SPECIFICATIONS: DUTY CYCLE, PERFORMANCE SPECIFICATIONS AND INPUT AMPERAGE INFORMATION 12,13
SETUP GUIDE: GETTING STARTED, UNPACKING YOUR UNIT, ASSEMBLY AND INSPECTION 14, 15
SETUP GUIDE: CONNECTING YOUR UNIT TO THE POWER SOURCE AND WIRING INFORMATION 16
SETUP GUIDE: SHIELDING GAS INFORMATION AND CONNECTION OF REGULATOR 18,19
SETUP GUIDE: POLARITY 19
SETUP GUIDE: MIG GUN, LINER, DRIVE ROLL, WIRE SPOOL INFORMATION 21-25
SETUP GUIDE: TUNGSTEN SELECTION AND GRINDING INFORMATION 26-27
FRONT PANEL VIEW AND COMPONENT ID 28
REAR PANEL VIEW AND COMPONENT ID 29
CONTROL PANEL LAYOUT 30
STARTING UP THE WELDER 31
GENERAL INFORMATION ON SETUP AND USE, GENERAL NAVIGATION INFORMATION 32-34
USING PROGRAMMABLE MEMORY FUNCTIONS 35, 36
USING THE MANUAL MENUS 37-42
USING THE POWERSET MENUS 42-43
USING THE TRIGGER/TORCH SWITCH REMOTE FUNCTIONS 45
EXPLANATION OF PARAMETERS, FUNCTIONS AND WELDING TERMS 46-54
NOVA WIRELESS FOOT PEDAL OPTION 55
24 SERIES MIG GUN AND PARTS 56
26 TORCH PARTS AND ASSEMBLY 57
TROUBLE SHOOTING: COMMON WELDING ISSUES 58-60
TROUBLE SHOOTING: ERROR CODES 61
MAINTENANCE 62
IMPORTANT!
Before operating the welder, read this manual from beginning to end. A thorough read-through of this manual is important to
help guide you in the safe and competent operation of the welder. This welder is a complex machine with many features that
new owners or users may not understand or be familiar with. The manual is written in a way that builds knowledge upon pre-
vious information presented in the manual. If sections are randomly read through, details of important information will be
missed. In certain sections, where details of operation may overlap, some information may be repeated from previous sec-
tions to highlight continuity between different functions and settings. Though some general welding information is given to
illustrate the parameters and functions of the welder, the manual is not meant to train or instruct in welding. The manual’s
scope and intent is to guide the professional user in safe use of the basic parameters and functions of the welder. Any ex-
plicit setting or detail offered in this manual is intended as a general guide, or a starting point, and should not be construed to
be a nal setting to be applied in any or all circumstances.
To Next Page
Loading...
