EasyManuals Logo

Evinrude & Johnson E90DPLSCB User Manual

Evinrude & Johnson E90DPLSCB
349 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #198 background imageLoading...
Page #198 background image
196
COOLING SYSTEM
THERMOSTAT SERVICING
THERMOSTAT
SERVICING
Disassembly
Remove the thermostat cover and O-ring from cyl-
inder head.
Remove spring, thermostat, and gasket.
Remove the cylinder head if cylinder head ther-
mostat seal requires replacement. Place new seal
in the cylinder head with side marked “TO CYL
HEAD” facing thermostat. Refer to Cylinder Head
Installation on p. 217.
Inspection
Inspect all parts for cracks, heat damage, or signs
of corrosion. Replace damaged parts. Clean
debris from housing and parts.
Assembly
Assembly is the reverse of disassembly. Pay
close attention when performing the following
additional tasks.
Coat threads of thermostat cover with Gasket
Sealing Compound and install new O-ring. Install
and tighten cover to a torque of 120 to 144 in. lbs.
(13.5 to 16 N·m).
006616
002444
1
1. Cylinder head seal 002445
000756
1

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Evinrude & Johnson E90DPLSCB and is the answer not in the manual?

Evinrude & Johnson E90DPLSCB Specifications

General IconGeneral
BrandEvinrude & Johnson
ModelE90DPLSCB
CategoryEngine
LanguageEnglish

Related product manuals