Evinrude E-TEC E50DPLSCB - Tiller Handle Removal; Tiller Handle Service - Long Handle

260
MIDSECTION
TILLER HANDLE SERVICE – LONG HANDLE
TILLER HANDLE
SERVICE – Long Handle
Removal
Use Remover tool, P/N 342226, to unsnap the
throttle cable clip from the throttle lever.
.
Remove the throttle cable anchor screw and
washer. Remove retainer clip from shift cable.
Remove cable retainer. Cut the tie strap holding
the tiller handle electrical harness.
Remove the electrical cover.
Disconnect the electrical harness coming from the
tiller handle.
Remove shift and throttle cables and wire harness
from grommet in lower engine cover.
WARNING
To avoid accidental starting of engine
while servicing, twist and remove all spark
plug leads.
1. Remover tool 005121
1. Throttle cable anchor
2. Shift cable retainer clip
3. Cable retainer
4. Tie strap
006745
1
4
3
1
2
1. Electrical cover 002509
Rope Start models
1. Electrical harness connector
002511
Tiller Electric models
1. Electrical harness connectors
001999
1
1
1