14
ICON Network Specifications and Information
Accessory Power Relay Kit
Accessory Power Relay Kit, P/N 765296,
must be used to power boat accessories
which require switched B+. This kit is used in
place of connecting accessories to the “A” ter-
minal of the key switch.
Engine Identity Numbers
Engine identity numbers are assigned to the
Electronic Servo Module (ESM) and Engine
Management Module (EMM) of each out-
board. Engine identity numbers allow the
ICON network to correctly control the out-
boards.
Note: Engine identity numbers assignment is
critical in multiple engine installations. Single
engine installations normally require no
change to identity number assignment.
The table below lists typical engine identity
number assignment.
Each outboard is identified by an engine iden-
tity plug installed in its ESM.
The first time the ICON system is turned ON,
it automatically checks engine identity num-
bers. During this time, the controls will not re-
spond to operator inputs. Allow approximately
3 seconds per engine for this check to com-
plete.
Check the engine identity plug number and be
sure the engine identity plug is installed as
outlined in the table.
IMPORTANT: Do not exchange ESMs or
EMMs between outboards. Severe engine
damage can result from improper replace-
ment of ESM or EMM.
Accessory Power Relay Kit
007940
Number of
Outboards
Identity Numbers
Port
Port
Center
Center
Starboard
Center
Starboard
10
20 1
30 1 2
401 23
5 01234
1. Engine identity plug
007525
1
To Next Page
Loading...