6
Operation
Emergency Stop Lanyard
Snap the emergency stop lanyard to a secure
place on the operators clothing or life vest –
not where it might tear away instead of acti-
vating the stop switch.
Disconnecting the clip of the emergency stop
lanyard from the master power/key switch will
stop all engines and prevent the boat from be-
coming a runaway if the driver moves beyond
the range of the lanyard. If the lanyard is too
long, it can be shortened by knotting it or loop-
ing it. DO NOT cut and retie the lanyard.
Master Power/Key Switch
Push the clip of emergency stop lanyard onto
the master power/key switch.
1. Emergency stop lanyard
005499
WARNING
Emergency stop lanyard MUST be
securely attached to the operator,
and clip MUST be installed on mas-
ter power/key switch. DO NOT oper-
ate outboard with clip removed from
switch, except in an emergency.
OFF
RUN
1
WARNING
Avoid knocking or pulling clip off the
stop switch during normal boating.
Avoid bumping the key if operating
without the clip on the switch. The
resulting unexpected loss of forward
motion can throw occupants forward
causing injury.
Keep the lanyard free from obstruc-
tions and entanglements.
At each outing, test the system’s
operation. With the engine running,
remove clip from the switch by pull-
ing the lanyard. If the engine does
not stop running, see your dealer.
1. Clip of emergency stop lanyard
2. Master power/key switch
007895
1. Clip of emergency stop lanyard
007896
OFF
RUN
2
1
1
2
1
To Next Page
Loading...