Evinrude ICON - Frequently Asked Questions

15
X EVINRUDE® ICON™ CONCEALED SIDE MOUNT REMOTE CONTROL USER’S GUIDE
FREQUENTLY ASKED QUESTIONS
Q: Does the Evinrude ICON electronic shift and throttle system require periodic calibration?
A: No. Normal use does not require periodic calibration. However, the system MUST be cali-
brated if the following services are performed:
•Replacement of throttle or shift actuator
•Replacement of Electro Servo Module (ESM)
•Replacement of Throttle Position Sensor (TPS)
•Shift linkage removal/installation
•Powerhead removal/installation
•Gearcase removal/installation
System calibration requires Evinrude Diagnostics software, version 4.0 or higher. See an
authorized Evinrude dealer when this important procedure is required.
Q: How do I make a flashing NEUTRAL indicator LED stop flashing?
A: Check emergency stop lanyard is in place. Move control lever to NEUTRAL position. Reset
the ICON system by turning the master power/key switch to the OFF position and then back
to the RUN position.
Q: The Station Protect feature does not appear to be working. What can cause this?
A: This option must be turned ON in the outboard’s Engine Management Module (EMM). Your
dealer must use Evinrude Diagnostics software (version 4.0 or higher) to turn ON this fea-
ture.
Q: My boat only has one fuel tank. Can the gateway module be configured to read other fluid
levels, such as “Oil Level” or “Water Level”?
A: No. The gateway module only provides a fuel level monitor. It cannot be configured to read
other fluid levels. See an authorized Evinrude dealer for accessory fluid level sensors.