Evolis Elypso - Post-Replacement Configuration and Cleaning; Configuration and Cleaning After Installation

42
³
6WHS&RQÀJXULQJWKHQHZSULQWKHDG

Power up the printer and check that it is properly connected to a computer on which the printer’s Evolis Print Center is
installed.

In Maintenance of Evolis Print Center, click on the Change print head tab.

(QWHUWKH3.1QXPEHURIWKHSULQWKHDGNLWLQEnter PKN no., the number you noted down in step 2. Then click &RQÀUP.
If the print head kit number is not entered correctly, printer malfunctions may occur and the warranty may be
voided.
³
Step 4 ? Cleaning the printer
On your printer’s control panel, the “CLEANING” light is lit:
Cleaning is absolutely necessary after changing the print head. No print jobs can be run until the cleaning
RSHUDWLRQKDVÀQLVKHG
Refer to section 3 – Maintenance to carry out cleaning.
Once cleaning has been carried out, your printer is once again ready to customise your cards.
Wait for 2 minutes after cleaning before using your printer.
4
CLEANING