3. Maintaining the cleaning roller
Your New Pebble printer has a cleaning roller. Its adhesive surface retains the dust when cards are
running through.
Although the cleaning of this roller is carried out during the automatic cleaning of the printer, it is
nevertheless recommended that you clean it regularly and simply with a cloth supplied with the
cleaning case in order to ensure that the card surface is perfectly clean.
To carry out the maintenance of the cleaning roller :
18
Français
FrançaisFrançais English
1. Open the printer cover.
2. Locate the roller and remove it from the printer
3. Clean the roller with a cloth from your cleaning case.
Remove all the dust by rubbing lightly with the cloth
over the whole surface of the roller. Wait for 2 minutes
for the cleaning fluid to evaporate completely. If neces-
sary, the cleaning roller can be cleaned under (cold) run-
ning water then dried with a fluff-free cloth or with a
neutral gas dust-removing spray
4. Once dry replace the roller in
the printer then close the
cover.
To Next Page
Loading...
Need help?
General
