3. Installing my printer
a) Installation of the interface and supply cables:
5
English
Français
Français
English
IMPORTANT !
To disconnect this product, pull the plug out of the socket, which
should remain easily accessible.
This product must be connected to an electrical installation correct-
ly protected and equipped with a protective earth.
Ensure that the printer
switch is in position 0
(switched off).
OR
1. Connect the supplied parallel
cable to your printer and fix
it by folding down the two
metal clips on the printer
onto the cable connector as
shown.
2. If you have a printer with a
USB port, connect the
supplied USB cable to your
printer as shown.
USB Port optional
3. Connect the other end of the
cable to the appropriate port
of your computer.
4. Connect the power cable to
the supply then plug in the
power cable connector to
the printer. Then connect the
end of the power cable to an
earthed mains power point.
To Next Page
Loading...
Need help?
General
