29
English
Français
Français
English
Introduction
New Pebble printers equipped with a magnetic strip encoder are known as New Pebble MAG
printers. The way that a New Pebble MAG printer works is identical to that of a New Pebble printer.
The magnetic encoder encodes ISO strips 1, 2 and 3 in a single movement before carrying out data
verification.
New Pebble MAG printer encoders can be set for high coercivity (HICO) or for low coercivity (LOCO)
simply by clicking on the Windows driver, but they leave the factory set by default for high
coercivity (HICO), unless specifically requested otherwise when ordering.
1. Position of the magnetic encoder
The magnetic encoder is a unit fitted in New Pebble MAG
printers in the factory. The read/write head is positioned
below the path taken by the cards and after the print head.
NOTE: the encoding sequence of a card is always performed
before a print session.
2. Position of cards
The magnetic strip cards must be installed in the
feeder in such a way that the magnetic strip is on
the underside and as close as possible to the back
of the printer (see opposite):
A.
Appendix A
Magnetic Encoding
To Next Page
Loading...
Need help?
General
