Evolis Zenius - Responding to Messages and Alerts

Page 16
Printer configuration using escape sequences
Escape sequence: Wireless LAN Security Type Array
Keyword: WST0
Value: The Wireless LAN security type for each individual SSID in the array.
0:
1:
2:
3:
4:
105:
106:
No security
WEP 64
WEP 128
WPA-PSK with TKIP encryption
WPA2-PSK with TKIP or AES encryption
WPA-TKIP Enterprise with EAP-TLS or PEAPMSCHAPv2. RADIUS
Certication Verication will be skipped
WPA2-AES Enterprise with EAP-TLS or PEAPMSCHAPv2. RADIUS
Certication Verication will be skipped
Example: Rwifi;WST0 or Pwifi;WST0;4
Escape sequence: Wireless LAN WEP Key Array
Keyword: WKY0
Value: The Wireless LAN WEP keys in the 4-slot WEP key array.
Value must be a Hexadecimal representation string, where each byte is described
by 2 ASCII characters in the range [0‘..‘9‘], [A‘..‘F‘] or [a‘..‘f‘].
When using 64-bit WEP (WST0=1), key may contain 10 characters (dening
5 bytes). When using 128-bit WEP (WST0=2), key may contain 26 characters
(dening 13 bytes).
Example: Rwifi;WKY0 or Pwifi;WKY0;WepKey
Escape sequence: Wireless Personal Shared Key Pass-Phrase
Keyword: WPP0
Value: The wireless LAN WPA-PSK pass-phrase.
For WPA2, the WSEC parameter must be set as well. If WSI0 (SSID) is not
empty, WPA-PSK security is enabled for WiFi connections and pass is used in
generating the WPA-PSK encryption key. The allowed value for pass is an ASCII
string containing 8-63 characters.
Example: Rwifi;WPP0 or Pwifi;WPP0;WpaPassphrase
Escape sequence: Domain and User name for WPA/WPA2 Enterprise mode
Keyword: EUSN
Value: Sets the login user name to be used for WPA/WPA2 Enterprise.
This parameter takes effect following either a hardware or software reset only.
A change to this parameter during the wireless interface operation does not
affect the current connection.
Example: Rwifi;EUSN or Pwifi;EUSN;Login_of_user
Escape sequence: Password for WPA/WPA2 Enterprise mode
Keyword: EPSW
Value: Sets the password to be used for WPA/WPA2 Enterprise.
This parameter takes effect following either a hardware or software reset only.
A change to this parameter during the wireless interface operation does not
affect the current connection.
Example: Rwifi;EPSW or Pwifi;EPSW;Password_of_user