ä
Removing printed cards
Once the print cycle is complete, cards are delivered into the output hopper below the card feeder. This output hopper is designed to
collect the printed and/or encoded cards. The printer is equipped with an output hopper with a maximum capacity of 20 x 0.76 mm
cards.
ä
Adjusting card thickness
The printer is equipped with a manual card thickness adjustment mechanism which can be reached through the inside of the printing unit
when the cover is open. The printer accepts card s varying in thickness from 0.25 mm to 0.76 mm. The factory setting is 0.76 mm.
10
1
To Next Page
Loading...
