Evolis Zenius - Step 3: Configuring the New Print Head; Step 4: Cleaning After Print Head Replacement

ä
Step 3 - Conguring the new print head
Ê
Power up the printer and check that it is properly connected to a computer on which the printer’s Evolis Print Center is
installed.
Ë
In Maintenance of Evolis Print Center, click on the Change print head tab.
Ì
Enter the PKN number of the print head kit in Enter PKN no., the number you noted down in step 2. Then click Conrm.
If the print head kit number is not entered correctly, printer malfunctions may occur and the warranty may be
voided.
ä
Step 4 - Cleaning the printer
On your printer’s control panel, the “CLEANING” light is lit:
Cleaning is absolutely necessary after changing the print head. No print jobs can be run until the cleaning
operation has nished.
Refer to section 3 – Maintenance to carry out cleaning.
Once cleaning has been carried out, your printer is once again ready to customise your cards.
CLEANING
43
4