Î
Remove any cards present in the feeder.
Ï
Double click the cleaning button on the control panel before inserting the cleaning card.
Ð
Take the "T" shaped cleaning card and insert it in the feeder as shown. Cleaning starts.
Ñ
Remove the "T" shaped card, then remove the lm from the adhesive cleaning card
Ê
and insert the cleaning card into
the manual feeder as shown, adhesive side up
Ë
. Cleaning starts.
Ò
The used cleaning card is ejected automatically by the manual feeder.
Warning, the "T" shaped card must be used just after the sachet is opened.
ÐÏ
Ñ
Î
Ò
Routine cleaning may also be carried out from the Evolis Print
Center by clicking on “Start cleaning”.
Before using your printer, remember to reset the gauge to the desired card thickness.
27
3
To Next Page
Loading...
