EVS XT Series - Software Releases Area; LSM; HCT; Network Area

Issue
10.01.D
XT Series DISK RECORDER
–
Version 10.01 - Software Technical Reference
EVS Broadcast Equipment SA
–
October 2009
28
SOFTWARE RELEASES AREA
LSM
This parameter displays the version number of Multicam software installed.
HCT
This parameter displays the version number and release date of HCT microcode
installed.
NETWORK AREA
SDTI
Possible values: [off / 540Mbps Relay / 540Mbps Non-Relay / 1485Mbps Non-
Relay]
This parameter makes it possible to enable the SDTI option and select the
bandwidth of the network.
On XT[2] servers, there are two pairs of SDTI connectors:
• XNet Relay connectors can be used at a maximum of 540 Mbps
• XNet[2] Non-Relay connectors can be used at either 540 or 1485 Mbps.
When connected on the SDTI network through Relay connectors, the SDTI loop is
always maintained, even if the XT[2] is not powered on.
When connected through Non-Relay connectors
, the SDTI circuit is closed only
when the Multicam software is started.
Important
The SDTI bandwidth must be identical on all XT[2] servers connected to
the XNet.
If one system is configured with a different bandwidth, it will block the
entire network.
The Disk Block Size parameter must be the same on all XT[2] servers.
Net Name
The Net name defines the machine name on the network. This name is user-
defined but cannot exceed 8 characters. Entering a Network Name is not
mandatory because a network number is also assigned to the system, but it is
recommended to easily identify all servers connected to the XNet.