EVS XT Series - Disk Monitoring and Genlock Status; Disk Monitoring

XT Series DISK RECORDER - Version 10.01 - Software Technical Reference Manual Issue
10.01.D
EVS Broadcast Equipment SA
–
October 2009
1
1. EVS Software
1.1 INTRODUCTION
The EVS software is used for configuration and maintenance operations. It is also
used to select which application to run, since EVS disk recorders have the ability
to run various dedicated applications (Video Server, Slow Motion, …).
When turning on the EVS mainframe, the first step is the PC boot sequence,
followed by the boot of the video I/O boards, and finally the EVS software is
started.
If a default application has been previously selected, this application will start
automatically after a few seconds if no key is hit.
If a default application has not been defined or if the space bar is hit, the system
will remain in the EVS main menu (see snapshot on next page) and wait for the
operator's next command.