EVS XT Series User Manual

Issue
10.01.D
XT Series DISK RECORDER
–
Version 10.01 - Software Technical Reference
EVS Broadcast Equipment SA
–
October 2009
42
If the Multicam is restarted without the RAID being rebuilt, the following message
is blinking during the Bootwins: “SCSI Controller #C disconnected in operation!”.
Then when entering the Multicam, another message appears:
To protect disk array integrity, a disk has been disconnected. At
the next opportunity please perform a hardware check to evaluate
the faulty disk, and perform a rebuild to correct the problem.
ESC: Exit Enter: Continue
The operator can press enter and operate normally on 4 disks or exit the software
and return to EVS menu to run a Hardware Check.
DISKS MONITORING
The Server Monitoring screen allows disk monitoring. Press Shift-F5 to access
this screen:
In the Disk Status section, the screen indicates the position of the disks on the
disk array and the status of each disk:
/ Not present
Dsk! Disconnected disk
OK Disk present
When a disk is disconnected, the message “Rebuild xx.xx%” will appear next to
the disk array to which the disconnected disk belongs. This value shows the
advance of the rebuild process. When a disk is disconnected but new pictures are
still being recorded on the disk array, this number will decrease until the disk is
replaced and the rebuild process starts. The rebuild is complete when this
number reaches 100%.

EVS XT Series Specifications

General

Brand	EVS
Model	XT Series
Category	Computer Hardware
Language	English