What to do if the USR LED remains red on eWON Network Router after a second level reset?
If the USR LED on your eWON Network Router remains steadily red after a second-level reset, power the eWON COSY off and then on again. This will reboot the unit into normal mode.
General| Brand | eWON |
|---|---|
| Model | Cosy 131 Ethernet |
| Category | Network Router |
| Language | English |
Overview of the installation guide and the eWON COSY 131 product.
Details the different versions available for the eWON COSY 131 family.
Lists key technical characteristics and their corresponding values for the hardware.
Describes common use cases and applications for the eWON COSY 131.
Lists the available product models and their corresponding part numbers.
Defines the purpose and coverage of the safety and regulatory section.
Specifies the safety and certification requirements for the external power supply.
Lists relevant European directives and standards the product conforms to.
Lists the specific safety standards the product adheres to for compliance.
Details compliance with FCC rules and the two conditions for operation.
Lists product certifications and where to download official documentation.
Covers conditions for proper operation and environmental factors affecting the device.
Specifies the IP rating and suitability for mounting environments.
Provides guidance on how to properly mount the eWON COSY unit.
Instructions for safely detaching the unit from a DIN rail mounting.
Details required clearances for proper heat dissipation and air flow.
Specifies requirements for Ethernet and USB cables for EMC compliance.
Lists operating and storage limits for temperature and humidity.
Explains the necessity of earthing for transient protection and EMC.
Details the CR2032 battery for RTC and replacement warnings.
Explains the information and markings found on the device's identification label.
Describes the structure and meaning of the product part numbers.
Provides the physical measurements and dimensions of the eWON COSY 131.
Identifies and describes components located on the front of the unit.
Details the main connector, its pinout, and associated labels.
Explains the function and meaning of status LEDs common to all versions.
Describes status LEDs specific to the WiFi model.
Describes status LEDs specific to the Cellular 3G+ model.
Introduces the different radio communication options available for the device.
Details protocols, frequencies, and antenna specifications for the WiFi model.
Details protocols, frequencies, and antenna specifications for the 3G+ model.
Provides specifications related to the device's LAN switch functionality.
Explains the device's behavior during power-on or reboot.
Lists the default IP address, subnet mask, and gateway for the device.
Describes the steps and LED indicators when powering on the device.
Guides on how to configure the device's IP address using the eBuddy tool.
Step-by-step instructions with screenshots for setting IP address via eBuddy.
How to access the device's web interface and initial language selection.
Covers initial device authentication and the configuration wizard.
Instructions on how to re-run the configuration wizard from the settings menu.
Describes the standard boot sequence and associated LED indicators.
Introduces the reset button and the different levels of resets available.
Explains how to perform a user reset and its effects on configuration.
Details the factory reset procedure and its impact on device settings.
A table detailing what is erased or preserved during different reset levels.
Describes the main connector type, pinout, and ID for each pin.
Details the requirements and specifications for the external power supply.
Explains the specifications and characteristics of the digital I/O ports.
Illustrates digital output wiring and describes its possible uses.
Explains how Digital Input 1 can be used as a connectivity condition.
Details the supported Wi-Fi channels and frequencies.
To Next Page
