FTB-2/FTB-2 Pro and FTB-4 Pro 403
B IEEE 488.2 and Specific
Command Reference
This chapter presents detailed information about the commands and
queries supplied with your unit.
IEEE 488.2 Commands–Quick Reference
Your unit recognizes the required commands identified in IEEE 488.2. The
table below summarizes these commands. These commands are fully
explained on the following pages.
Command Function
*CLS Clear status command
*ESE Standard event status enable command
*ESE? Standard event status enable query
*ESR? Standard event status register query
*IDN? Identification query
*OPC Operation complete command
*OPC? Operation complete query
*RST Reset command
*SRE Service request enable command
*SRE? Service request enable query
*STB? Read status byte query
*TST? Self-test query
*WAI Wait for pending operations to be completed
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
Need help?
General
