EXFO FTB-4 Pro - Page 415

IEEE 488.2 and Specific Command Reference
FTB-2/FTB-2 Pro and FTB-4 Pro 405
IEEE 488.2 Required Commands
*ESE
Description The *ESE command sets the Standard Event
Status Enable Register bits, as defined in the
table below. This register contains a mask value
for the bits to be enabled in the Standard Event
Status Register.
Syntax *ESE<wsp><RegisterValue>
Parameter(s) RegisterValue:
The program data syntax for <RegisterValue> is
defined as a <DECIMAL NUMERIC PROGRAM
DATA> element.
The <RegisterValue>, expressed in base 2,
represents the bit values of the Standard Event
Status Enable Register.
PON URQ CME EXE DDE QYE N.U. OPC
MSB LSBStandard Event Status Enable Register
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com