DIAMANT Pro
19
Adjusting the water softener/filter regeneration alert setting
To adjust the number of litres required to activate the water lter/softener change or regeneration alert
follow the steps below:
1. Enter the ‘Technician setting’ menu.
2. When ‘Water lter’ is shown on the display, press to increase value and to decrease
value. Setting will be saved when pressed the icon and text is white.
3. If you want to go to main screen again press .
Adjusting the service cycle counter setting
To adjust the number of cycles required to activate the service alert follow the steps below:
1. Enter the ‘Technician setting’ menu.
2. When ‘Service cycle’ is shown on the display, press to increase value and to decrease
value. Setting will be saved when pressed the icon and text is white.
3. If you want to go to main screen again press .
Enabling/disabling group cleaning warning
To enable or disable the group cleaning warning option follow the steps below:
1. Enter the ‘Technician setting’ menu.
2. When ‘Cleaning warning’ is shown on the display, press to go next option and to go
previous option. Setting will be saved when pressed the icon and text is white.
- Enabled (As default): Activates the group cleaning warning, which will be triggered after
‘x’hours from the last group cleaning.
- Disabled: Disables this alarm.
3. If you want to go to main screen again press .
Enabling/disabling group over-use warning
To enable or disable the group over-use warning option follow the steps below:
1. Enter the ‘Technician setting’ menu.
2. When ‘Group over-use warning’ is shown on the display, press to go next option and
to go previous option. Setting will be saved when pressed the icon and text is white.
- Enabled (As default): Activates the group over-use warning, which will be triggered based in
the triggers ‘Group over-use trigger’ and ‘Group over-use minimum’ from the Barista menu.
- Disabled: Disables this alarm.
3. If you want to go to main screen again press .
SERVICE PROGRAMMING: TECHNICIAN SETT.
To Next Page
Loading...
