DIAMANT Pro
20
SERVICE PROGRAMMING: TECHNICIAN SETT.
Change technician settings password
To change the password to access the technician settings programming menu follow the steps below:
1. Enter the ‘Technician setting’ menu.
2. When ‘Change password’ is shown on the display, press to go next character and to
go previous character, with the icon you forward one letter. Setting will be saved when
pressed the icon and text is white.
3. If restored, the password will be reset to 666 as default.
4. If you want to go to main screen again press .
FMU
To enable or disable the group cleaning warning option follow the steps below:
1. Enter the ‘Technician setting’ menu.
2. When ‘FMU’ is shown on the display, is shown on the display, press and to select the
preferred setting. Setting will be saved when pressed the icon and text is white.
3. If you want to go to main screen again press .
To Next Page
Loading...
