Expobar G-10 Service Manual

28
G-10
R
SERVICE PROGRAMMING
Accessing service programming
STAND-BY (OFF)
Next menu
Stand-by + Press >14 s → Service prog.
ON
+ - OK
Language selection
Accessing these settings menus is only possible via the left-hand button panel (when
the machine is viewed from the front).
To access the settings menus:
Turn the machine OFF (stand-by) by pressing and holding down the Continuous
Dispensing button
whilst the machine is ON then pressing the 2 Short
Espressos button
(see fig. 11).
Hold down the Continuous Dispensing button for 15 seconds (until the
display shows the "Language" option, see fig. 12).
OFF hh:mm
Fig. 11
When "Language" is displayed, select the desired language.
To change language:
Press the 1 Short Espresso button (+) to cycle forward through the languages
and the 1 Long Espresso button
(-) to cycle backward through them.
Languages available: Spanish, English, French, Italian, German and Portuguese.
To accept the language selected and access the next menu, press the Continuous
Dispensing button
.
Language
Language
Fig. 12
Reset parameters to factory default
Data reset
completed
Fig. 10
To reset the control panel settings to the factory default:
Switch off the machine at the power switch.
Press and hold down the '1 Short Espresso' , 2 Short Espressos and
Continuous Dispensing buttons
then turn on the machine. Hold down the
buttons until the message shown in fig. 10 is displayed.
Turn the machine off and then on again. The machine will now be in stand-by mode.

Expobar G-10 Specifications

General

Brand	Expobar
Model	G-10
Category	Coffee Maker
Language	English